THE CHOICE OF MATERIAL FOR THE SEALING ELEMENT OF THE GATE VALVE ASSEMBLY
- Details
- Category: Uncategorised
- Published: Friday, 30 September 2022 17:32
- Written by Administrator
- Hits: 1713
Volume 12 (4), September 2022, Pages 04-11
1Ibrahim Habibov, 2Oleq Dyshin, 3Zohra Garayeva
1Professor, Director of the design center “Engineer" ,Azerbaijan State Oil and Industry University, Doctor of technical sciences, Azerbaijan. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.. https://orcid.org/0000-0003-3393-7812
2 Senior Researcher, Research Institute "Geotechnological Problems of Oil, Gas and Chemistry", Azerbaijan.
3Assistant, Department of Industrial Machines, Azerbaijan State Oil and Industry University, Azerbaijan. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.. https://orcid.org/0000-0001-8824-623X
ABSTRACT
The article is devoted to the choice of material for the sealing element of the gate assembly of gate valves. Two new composite materials have been proposed as a material for the sealing element of the valves. Where the following are selected as the matrix: butadiene-nitrile rubber of the brand SKN-26 and fluoroplast of the brand FT4. It is shown that both composite materials can be used to manufacture sealing elements for high-pressure valves. At the same time, samples from the composition with a fluoroplast matrix show the best resistance to chemical influences. It was also found that the factor of nanoparticles in the composite material contributes to the formation of a stable structure with increased physical and mechanical characteristics.
Keywords: gate valve, sealing element, gate, synthetic butadiene-nitrile rubber mixture, composite material.