MATHEMATICAL EXPRESSIONS FOR TEMPERATURE IN THE CONTACT ZONE OF TEETH OF THE GEAR MECHANISMS

Details
Category: Uncategorised
Published: Wednesday, 19 April 2023 17:11
Written by Administrator
Hits: 2378

Volume 14 (2), April 2023, Pages 126-134

Amir Mustafayev1, Chingiz Nasirov2

1Associate Professor, Department of Mechanics, Azerbaijan State Oil and Industry University, Azerbaijan. Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

2Master, Department of Transportation and Storage of Oil and Gas, Azerbaijan State Oil and Industry University, Azerbaijan. Email: This email address is being protected from spambots. You need JavaScript enabled to view it.

 ABSTRACT

 Transmission gears are very widely used in modern machine building. Despite that electrical transmissions used in machine building industry, mainly mechanical transmissions are widely used in the industry. Because mechanical transmissions are independent and better than other transmisions.

Distributing power between the transmission mechanisms and working units of various machines, changing the angle of momentum, by adjusting the speed of the parts, it is possible to change the type of movement, turn on and off the mechanism, change the direction of the transmission mechanisms.

One of the most widespread types of transmission technology is the gear transmission. Tens of thousands of kilowatt-hours of gears can be transmitted.

Advantages of gear transmission in comparison with others is their ability to maintain their reliability and long term functioning of the teeth, big value of the working coefficient (0,9 ÷ 0,99), simple construction, lack of special service, simplicity of the transmission number and compactness of dimensions.

The missing aspects of these transmissions are high precision in their preparation and installation, and low noise level.

The main criterion for the working ability of the closed gear transmissions is the contact endurance of the active surface of the tooth. For this reason, the main dimensions of the transmission are determined by the contact tension and by teeth bending.

Key words: gear wheel, tension, endurance, bending