TUBING HANGER INVESTIGATE OF LOADING

Подробности
Категория: Uncategorised
Опубликовано: 18.04.2023 18:59
Автор: Administrator
Просмотров: 2607

Volume 14 (2), April 2023, Pages 70-76

Zenfira Huseynli1, Alieva Rovshana2, Akbar Hashimov3, Gulnara Feyziyeva4

1Associate professor, department of “Industrial Machines”, Azerbaijan State Oil and Industry University, phd in technical sciences, Azerbaijan. Email id: Этот адрес электронной почты защищён от спам-ботов. У вас должен быть включен JavaScript для просмотра.

2Laboratory assistant, department of “Industrial Machines”, Azerbaijan State Oil and Industry University, phd in technical sciences, Azerbaijan.

3Master student, Azerbaijan State University of Oil and Industry, Azerbaijan. E-mail: Этот адрес электронной почты защищён от спам-ботов. У вас должен быть включен JavaScript для просмотра.

4Teacher, “Industrial Machines”, Azerbaijan State Oil and Industry University, Azerbaijan. E-mail: Этот адрес электронной почты защищён от спам-ботов. У вас должен быть включен JavaScript для просмотра.

 ABSTRACT

 In this article, the failures of tube hangers made from UNS N07718 are discussed. An arrangement known as a tubing hanger may be found in wells that produce either oil or gas. It is positioned in the upper tubing head’s bowl after it has been installed. The tubing is held in place by this, and a main annulus seal is created between tubing also the production casing. This holds the tubing in place, and at the same time, it creates a primary annulus seal between tubing also production casing. When compared to odd component in wellhead system, tubing hangers are available in a broader range of styles and sizes than any other option. Tubing hangers made of UNS N07718 are often used in the installation process of sour service oil and gas wells that operate under high pressure and also high temperatures. Afterwards more than 10 years of service, it was only recently found that the tubing hanger made of UNS N07718 had failed in sour wells. Failures of the tubing hanger will inference in substantial production delays as well as high workover expenses. The purpose of this research is to demonstrate the failure mechanism of tubing hanger furthermore its ramifications on existing wells that were erected with material that is comparable to what was used here. In order to establish what caused the failure, each and every exposure that was brought on by well intervention efforts was evaluated. The manner of failure of stringer head suspension was researched, as was its influence on already existing wells that had been erected with materials that were comparable.

Keywords: tubing head, tubing hanger, tubing thread, back pressure valve profile, landing shoulder, snap ring, running thread.