HYDRODYNAMIC CALCULATION OF MASS-EXCHANGE SYSTEMS OF TECHNOLOGICAL DEVICES

Details
Category: Uncategorised
Published: Monday, 26 August 2019 00:12
Written by Administrator
Hits: 3093

MAMEDOV G.A., ISMAYLOV R.Sh.

Azerbaijan State University of Oil and Industry

Annotation. The hydrodynamic method for calculating mass transfer systems of technological installations is given. To this end, the vector equation of motion of the fluid flow of variable mass is transformed into a one-dimensional form. A mathematical model of the one-dimensional flow of ideal and real liquids in mass transfer devices has been developed. Taking into account the different zones of resistance and flow regimes, a generalized formula for calculating mass transfer systems is obtained from the differential equation of a one-dimensional flow with continuous flow rate distribution. Comparison of calculated and experimental data shows their adequacy.

Keywords: Hydrodynamics, mass transfer devices, fluid with variable mass, potential flow, viscous fluid, coefficient of hydraulic friction.

EFFICIENCY IMPROVEMENT OF PLUGS OF ROD DRAIN PUMPS

Details
Category: Uncategorised
Published: Monday, 26 August 2019 00:09
Written by Administrator
Hits: 3437

ALIEV E.A., HASANOV Q.S.

Azərbaycan Dövlət Neft və Sənaye Universiteti

Abstract: The methods of strengthening the working surface of plungers of submersible sucker-rod deep pumps are considered in work. According to the conducted research, it was established that the cuff method and the method of cold ironing is an alternative option for gas-flame spraying and it reduces labor-intensiveness and material consumption by increasing the wear resistance of plungers of submersible sucker-rod deep-well pumps. The plunger of the submersible sucker rod pumps, were tested under production conditions and it was found that their working capacity is averagely two times greater than that of the pumps sprayed by the flame method.

Keyword: Key words: sucker rod pumps, hardening, wear resistance, cuff plunger, cold ironing, chrome plating, flame spraying.

BASIC INITIAL PRECONDITIONS FOR FURTHER EVOLUTION MOBILE RISING OIL FIELD UNITS

Details
Category: Uncategorised
Published: Monday, 26 August 2019 00:06
Written by Administrator
Hits: 3171

1BABAEV S.H., 2HABIBOV I.A., 3FEYZIEV I.A

1SRİ “Geotechnological problems of oil, gas and chemistry"

2Azerbaijan State University of Oil and Industry

3OJSC "Baku oil and gas field equipment"

Abstract. The article is devoted to the development of basic requirements for modern mobile lifting installations in accordance with the industry standard. An analysis of the state of the evolution of installations in conjunction with the characteristic of the “life cycle” of these technical systems and the law of progressive evolution is given. Based on the results of the expert assessment, the most significant priority tasks were identified, related to the further improvement of the quality of facilities, with coverage of a number of capacities established by the industry standard.

Keywords. mobile lifting systems, evolution, life cycle, expert assessment.