ANALYSIS OF CRACKS AT THE TORSION VALLARS CAUSED WITHOUT LOADING

Details

Category: Uncategorised

Published: Monday, 07 June 2021 19:35

Written by Administrator

Hits: 1510

Volume 7 (3), June 2021, Pages 74-81

Tehran Mammadli

Master, Azerbaijan Technical University, Azerbaijan. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.. https://orcid.org/0000-0003-4212-7416 

ABSTARCT

 Nowadays, the hull suspension systems that use torsion shafts as elastic suspension elements are fitted to the majority of modern tracked vehicles. The main type of failure in such systems is the fracture of the torsion shafts due to the formation of fatigue cracks, which leads to failure of the suspension assemblies. This work presents an analysis of fracture toughness of torsion shafts of a standard tracked chassis used to develop a family of  multipurpose transport vehicles GT-TM, GT-TMS, etc. The analysis is carried out under an operating load level for a crack located on the cylindrical part of the torsion shaft, the plane of which is at an angle to the torsion shaft axis and coincides with the position of the main areas of the stress state. The calculation of fracture toughness is based on Irwin fracture criterion. The calculations of the maximum stress intensity factor along the crack front are performed using the finite element method in the ANSYS software package. The results of the analysis of fracture toughness are presented in the form of dependences of the critical depth of the crack on the ratio of the fracture half-length to its depth. The data obtained can be used to determine the residual life of torsion shafts of the tracked vehicles based on the chassis under consideration.

Keywords: suspension system, fracture toughness of torsion shafts, edge crack, stress intensity factor, finite element method, Irwin fracture criterion.